Varisoft EQ 65 MB – Conditioning Agent – COSMOS APPROVED

VARISOFT EQ 65 MB Biodegradable ester quat with excellent conditioning performance!!! INCI Name : Distearoylethyl Dimonium Chloride; Cetearyl Alcohol Active Matter : 65% Recommended usage concentration : 0 to 10% Recommended PH Level : 4 and Below Soluble in Water Can Be used for: Hair conditioners (rinse-off and leave-in) – As a Conditioning Agent Skin care creams and lotions – As a Emulsifier Sun Care – Because of the Smooth Feel on Skin Benefits at a glance: Excellent conditioning agent with good cost Readily biodegradable COSMOS Certified Solvent-free and high flash point Vegetable based , Readily biodegradable Improved compatibility Soft and smooth hair feel , Improves detangling Substantive to hair and skin Provides good wet feel of hair Superior dry combing and dry feel of hair FORMULATION GUIDE: Varisoft EQ 65 Contains 65% of Distearoylethyl Dimonium Chloride and 35% of Cetearyl Alcohol. Fatty Alcohol like Cetyl Alcohol can be added at 0.5% for every 1% of Varisoft to increase Conditioning. Preservative can be added at 40° C while mixing and allow it to cool. If the emulsions and conditioners has a small oil phase, Varisoft EQ 65 can be measured into the water phase and heated to 75°- 85°C along with any other heat tolerant oil or water soluble ingredients or dispersed into the water at 80°- 85°C. In emulsions and conditioners with a larger oil phase, Varisoft EQ 65 and other oil or silicone soluble ingredients may be heated at up to 85°C. The water phase has to be heated to a similar temperature. And then both can be added at high shear. Allow to cool to 40°C (104°F) before adding preservative, fragrance or essential oils, or other cool down ingredients. Allow the product to cool to room temperature before mixing again for 30 seconds to 1 minute to obtain optimal viscosity. In any product, the pH should be adjusted at the end of the formulating process to pH 4 to 4.5 as it can hydrolyze at pH levels higher than 5. This can be done by adding drops of a solution of 50% Citric Acid Solution and testing until it reaches ideal pH.